Home › Concrete cities › Nebraska

Concrete Driveway Cost in Nebraska (2026)

Concrete driveway pours in Nebraska typically run $3,000–$8,000 for a 600 sq ft 4-inch concrete driveway pour at 4000 psi compressive strength. Buried footings must clear the 42-inch design frost line, and the state sits in severe freeze-thaw exposure (ACI F2). Nebraska's combination of 42-inch frost depth across the entire state, F2 (severe) freeze-thaw exposure across the central-plains, and central-plains hailstorms with 2-inch+ diameter routinely damaging fresh concrete cure cycles drives 6%+ air-entrainment plus protective sheeting on every residential pour during severe weather alerts — and Nebraska road de-icing salt exposure on every grade-level driveway edge from Nebraska Department of Transportation snow operations plus Lincoln-Omaha winter chinook wind events drive 0.40 maximum water-cement ratio on every Nebraska residential pour.

State Nebraska
Cities Covered 4
Typical 600 sq ft 4-inch concrete driveway pour $3,000 – $8,000
BLS cement mason wage $27.42/hr

Nebraska climate, soil & seismic drivers

  • Frost-line trench depth: 42-inch design minimum for buried footings
  • Freeze-thaw exposure (ACI 201.2R): F2 — severe freeze-thaw + de-icer exposure, 5-7% air-entrainment required
  • Typical residential mix: 4000 psi compressive strength
  • Expansive soil risk: Moderate — periodic clay shrink-swell, standard footing reinforcement adequate
  • Sulfate exposure (ACI 318): S1 — moderate sulfate exposure, ASTM C150 Type II cement required
  • Seismic design category (ASCE 7-22): SDC B — minor seismic risk, standard tie-down requirements
  • Winter de-icer salt exposure: High — winter de-icing salt drives air-entrainment + corrosion-protected rebar

Nebraska licensing & permits

  • License status: Statewide registration required (no exam)
  • License board: Nebraska Department of Labor — Contractor Registration (official site)
  • Permit: city or county building permit required for residential driveway pour > 200 sq ft; Nebraska Contractor Registration required statewide above $2,500 annual gross

How concrete driveway costs vary in Nebraska

State-specific code or insurance rule: Nebraska Revised Statute §48-2103 requires every Nebraska concrete contractor performing more than $2,500 in annual gross construction work to register with the Nebraska Department of Labor — Nebraska is one of the lowest-threshold registration states in the country, and Nebraska Department of Roads Specifications 503 requires statewide aggregate-source certification on every concrete pour for ASR (alkali-silica reaction) prevention given Nebraska's high-reactivity central-plains aggregate deposits, with University of Nebraska-Lincoln Construction Materials Lab providing mandatory aggregate testing on every residential foundation pour above 1,000 sq ft.

Cities in Nebraska

Compare concrete driveway pricing for 4 cities across Nebraska.

Bellevue, NE

Compare local concrete driveway pricing in Bellevue.

Grand Island, NE

Compare local concrete driveway pricing in Grand Island.

Lincoln, NE

Compare local concrete driveway pricing in Lincoln.

Omaha, NE

Compare local concrete driveway pricing in Omaha.

Got a quote? Check if it's fair.

Upload your estimate for an instant price and scope review tuned to Nebraska labor and material rates.

Analyze your quote

More state guides

Pricing ranges reflect Nebraska market labor (BLS OEWS cement mason & concrete finisher mean $27.42/hr) and Woogoro regional cost modeling. For the most localized estimate, see your nearest city page above.