Home › Concrete cities › Alabama

Concrete Driveway Cost in Alabama (2026)

Concrete driveway pours in Alabama typically run $3,200–$8,800 for a 600 sq ft 4-inch concrete driveway pour at 3000 psi compressive strength. Buried footings must clear the 6-inch design frost line, and the state sits in no freeze-thaw exposure (ACI F0). Alabama's combination of red-clay subsoil across Birmingham, Tuscaloosa, and Montgomery requires aggressive 4-to-6-inch crushed-stone gravel base under every driveway pour to prevent clay-driven slab heave during seasonal moisture cycles — and Mobile-Baldwin coastal humidity drives rapid set times on every Gulf Coast pour, with retarder admixtures standard on every Alabama coastal residential pour during May-September high-humidity season.

State Alabama
Cities Covered 12
Typical 600 sq ft 4-inch concrete driveway pour $3,200 – $8,800
BLS cement mason wage $21.42/hr

Alabama climate, soil & seismic drivers

  • Frost-line trench depth: 6-inch design minimum for buried footings
  • Freeze-thaw exposure (ACI 201.2R): F0 — no freeze-thaw exposure, no air-entrainment required
  • Typical residential mix: 3000 psi compressive strength
  • Expansive soil risk: Moderate — periodic clay shrink-swell, standard footing reinforcement adequate
  • Sulfate exposure (ACI 318): S0 — no sulfate exposure, Type I/II cement adequate
  • Seismic design category (ASCE 7-22): SDC C — moderate seismic risk, continuous-rebar-tie footings required
  • Winter de-icer salt exposure: Low — minimal winter de-icer use

Alabama licensing & permits

  • License status: Statewide license required
  • License board: Alabama Home Builders Licensure Board (residential >$10,000) (official site)
  • Permit: city or county building permit required for driveway > 200 sq ft on new construction; HBLB residential license required above $10,000 contract

How concrete driveway costs vary in Alabama

State-specific code or insurance rule: Alabama Code §34-14A-5 makes the Alabama Home Builders Licensure Board the only state body that licenses residential concrete contractors above the $10,000 contract threshold — and the HBLB requires a Limited Specialty Construction credential with a separate examination on flatwork, footings, and post-tension foundation work, plus Alabama is one of the only Southeast states requiring a separate Alabama Department of Environmental Management Stormwater NOI on every concrete pour above 1 acre disturbed area for residential subdivisions.

Cities in Alabama

Compare concrete driveway pricing for 12 cities across Alabama.

Auburn, AL

Compare local concrete driveway pricing in Auburn.

Birmingham, AL

Compare local concrete driveway pricing in Birmingham.

Decatur, AL

Compare local concrete driveway pricing in Decatur.

Dothan, AL

Compare local concrete driveway pricing in Dothan.

Florence, AL

Compare local concrete driveway pricing in Florence.

Hoover, AL

Compare local concrete driveway pricing in Hoover.

Huntsville, AL

Compare local concrete driveway pricing in Huntsville.

Madison, AL

Compare local concrete driveway pricing in Madison.

Mobile, AL

Compare local concrete driveway pricing in Mobile.

Montgomery, AL

Compare local concrete driveway pricing in Montgomery.

Phenix City, AL

Compare local concrete driveway pricing in Phenix City.

Tuscaloosa, AL

Compare local concrete driveway pricing in Tuscaloosa.

Got a quote? Check if it's fair.

Upload your estimate for an instant price and scope review tuned to Alabama labor and material rates.

Analyze your quote

More state guides

Pricing ranges reflect Alabama market labor (BLS OEWS cement mason & concrete finisher mean $21.42/hr) and Woogoro regional cost modeling. For the most localized estimate, see your nearest city page above.