Foundation Cost in Wyoming (2026)

New-construction foundation pours in Wyoming typically run $18,400–$41,400 for a full-house 2,000 sq ft new-construction foundation pour, with full basement pour as the dominant residential foundation type. Buried footings must clear the 48-inch design frost line. Wyoming's combination of 48-inch frost depth across the entire state, F3 freeze-thaw exposure driving 6-8% air-entrainment specification, Powder River Basin bentonite-clay shrink-swell expansive-soil hazard across Sheridan, Campbell, Johnson, Natrona, Converse, and Niobrara counties driving caisson-pier or post-tension foundation specification, statewide radon zone 1 designation forcing sub-slab depressurization rough-in on every residential basement pour, high alkaline soil sulfate exposure (S2 ACI 318 category) along the Powder River Basin forcing ASTM C150 Type II sulfate-resistant cement specification, and Yellowstone hot-spot near-fault design requirements in northwestern Wyoming drives aggressive frost-and-bentonite-driven foundation engineering.

State Wyoming
Cities Covered 2
Typical full-house 2,000 sq ft new-construction foundation pour $18,400 – $41,400
BLS construction-laborer wage $22.84/hr

Wyoming climate, soil, seismic & hydrologic drivers

  • Frost-line trench depth: 48-inch design minimum for buried footings
  • Dominant residential foundation type: Full basement — dominant in Upper Midwest, Northeast, and Mid-Atlantic on freeze-thaw + radon-zone-1 sites
  • Expansive soil risk: High — expansive clay subsoil requires geotechnical investigation + reinforced footings
  • Seismic design category (ASCE 7-22): SDC B — minor seismic risk, standard tie-down requirements
  • Hurricane wind tier: No hurricane wind-design exposure
  • Water table risk: Low — deep water table, no sump-pump rough-in required
  • Sulfate exposure (ACI 318): S2 — severe sulfate exposure, ASTM C150 Type II/V cement required
  • IECC climate zone: 6B-7
  • EPA radon zone: Zone 1 (highest) — passive sub-slab depressurization rough-in required on every basement and slab pour

Wyoming licensing & permits

  • License status: No statewide trade license
  • License board: Wyoming has no statewide residential builder license — Wyoming Department of Workforce Services oversees specialty trades only (official site)
  • Permit: city or county building permit required for residential foundation pour; no state foundation contractor license; Powder River Basin bentonite-swell expansive-soil disclosure recommended; statewide radon zone 1 designation drives sub-slab depressurization rough-in

How foundation pour costs vary in Wyoming

State-specific code or insurance rule: Wyoming has no statewide residential builder license — Wyoming Department of Workforce Services oversees only specialty trades like plumbers, electricians, and oil-burner installers, leaving foundation contractor competency and bond entirely to municipal building departments and homeowner due diligence, and Wyoming is unusual among Mountain West states in operating no statewide bond-or-registration requirement for foundation contractors, plus Wyoming State Geological Survey separately publishes Powder River Basin bentonite-clay shrink-swell expansive-soil maps identifying Sheridan, Campbell, Johnson, Natrona, Converse, and Niobrara county residential foundation hazard zones, with WY Department of Health statewide radon zone 1 designation driving sub-slab depressurization rough-in.

Cities in Wyoming

Compare foundation pour pricing for 2 cities across Wyoming.

Got a quote? Check if it's fair.

Upload your estimate for an instant price and scope review tuned to Wyoming labor and material rates.

Analyze your quote

More state guides