Foundation Cost in New Hampshire (2026)

New-construction foundation pours in New Hampshire typically run $21,400–$49,400 for a full-house 2,000 sq ft new-construction foundation pour, with full basement pour as the dominant residential foundation type. Buried footings must clear the 48-inch design frost line. New Hampshire's combination of 48-inch frost depth across the southern half plus deeper frost in the White Mountains, F3 freeze-thaw exposure driving 6-8% air-entrainment specification, statewide radon zone 1 designation forcing sub-slab depressurization rough-in on every residential basement pour, and New Hampshire mountain elevations above 4,000 feet driving frost-protected shallow foundation (FPSF) detailing as an alternative to deep frost-line excavation drives aggressive frost-protection and radon-control engineering on every NH residential foundation pour, with North Country granite-bedrock subsoil additionally requiring rock-anchor-tied footings on every elevated White Mountain residential pour.

State New Hampshire
Cities Covered 3
Typical full-house 2,000 sq ft new-construction foundation pour $21,400 – $49,400
BLS construction-laborer wage $24.84/hr

New Hampshire climate, soil, seismic & hydrologic drivers

  • Frost-line trench depth: 48-inch design minimum for buried footings
  • Dominant residential foundation type: Full basement — dominant in Upper Midwest, Northeast, and Mid-Atlantic on freeze-thaw + radon-zone-1 sites
  • Expansive soil risk: Low — sandy or stable subsoil, standard slab-on-grade design
  • Seismic design category (ASCE 7-22): SDC B — minor seismic risk, standard tie-down requirements
  • Hurricane wind tier: Low — sub-110 mph design wind, minimal tie-down detailing
  • Water table risk: Moderate — water table below frost line in most lots
  • Sulfate exposure (ACI 318): S0 — no sulfate exposure, Type I/II cement adequate
  • IECC climate zone: 5A-6A
  • EPA radon zone: Zone 1 (highest) — passive sub-slab depressurization rough-in required on every basement and slab pour

New Hampshire licensing & permits

  • License status: No statewide trade license
  • License board: New Hampshire has no statewide residential builder license — NH Office of Professional Licensure & Certification oversees specialty trades only (official site)
  • Permit: town or municipal building permit required for residential foundation pour; no state foundation contractor license; New Hampshire State Building Code 2018 IRC + 2018 IECC mandatory; statewide radon zone 1 designation drives sub-slab depressurization rough-in

How foundation pour costs vary in New Hampshire

State-specific code or insurance rule: New Hampshire has no statewide residential builder license — NH Office of Professional Licensure & Certification oversees only specialty trades like plumbers, electricians, and oil-burner installers, leaving foundation contractor competency and bond entirely to municipal building departments and homeowner due diligence, and the New Hampshire State Building Code (2018 IRC + 2018 IECC) separately mandates frost-protected shallow foundation (FPSF) detailing as an alternative to deep frost-line excavation on every residential pour above the 4,000-foot White Mountain elevation line, with NH Department of Health and Human Services statewide radon zone 1 designation driving sub-slab depressurization rough-in.

Cities in New Hampshire

Compare foundation pour pricing for 3 cities across New Hampshire.

Got a quote? Check if it's fair.

Upload your estimate for an instant price and scope review tuned to New Hampshire labor and material rates.

Analyze your quote

More state guides